Position and height
Basin set at a practical height and checked level before any connection is made.
Farwaniya
Ablution basin in Abraq Khitan
Ablution basin installation in Abraq Khitan starts by tracing lateral water lines and floor traps under thick concrete. We position the basin near the existing trap. We run both supply and waste lines together and test under stable pressure before final handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Villas in Abraq Khitan are built on rocky ground with deep foundations and thick concrete floors. Floor traps usually sit in the main bathroom and may be deeper than other bathrooms. This means opening the floor needs specialized equipment and may hit sand layers beneath. We use an electric tracer first to map existing pipes and avoid collision. We cut a precise-width channel at a specific depth and run the new pipe parallel to old lines. We fill the channel with cement mortar after installation and testing and level the surface for tiling.
Abraq Khitan lies in Farwaniya governorate away from the sea, a relatively modern villa district with strong floors and original pipework meeting high standards.
We use a digital slope meter to ensure steady gradient on the new waste line under thick concrete.
What the installation covers
Waste connection
Trap and rubber seal fitted so waste drains fully with no odour return.
Supply lines
Braided flexible tails connected to isolation valves for future servicing.
Mixer fitting
Single-lever or separate taps set with PTFE tape and thread compound at every joint.
Silicone sealing
Non-fungal sanitary silicone applied along the full basin perimeter to keep moisture out.
Handover test
Flow confirmed and every joint inspected for drips before the technician leaves.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Ablution basin
Other services in Abraq Khitan
Bathtub installation
See the detailsJacuzzi installation
See the detailsShower cabin
See the detailsShower installation
See the detailsCommon questions
Questions about Ablution basin in Abraq Khitan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is cutting the thick concrete floor risky for the house structure?
Completely safe if we avoid existing pipes and cables. We scan the floor first with an electrical tracer and cut a narrow channel away from all existing lines.
After installation, do we need to add cement supports?
Yes, we fill the channel with strong cement mortar after testing the new pipes completely. We level the surface and allow it to set for four hours before tiling.
