Position and height
Basin set at a practical height and checked level before any connection is made.
Hawalli
Ablution basin in Salam
Replacing a worn ablution basin in Salam is a different job from fitting a first one. Our installation service removes the old unit, checks the existing supply stubs and waste outlet, then sets the new basin, connects it and tests it under running water.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many houses around Salam Co-op were fitted with ceramic foot basins years ago, and the fittings behind them are often the weak point. Before setting a replacement we open the old isolation valves, check the threads on the supply stubs and look inside the waste outlet for scale or cracked sleeves. Where the old basin had a different outlet height, we adjust the waste connection so the new one drains fully.
Salam is a Hawalli residential district served by Salam Co-op, with many family houses now replacing their first ablution fittings.
Old isolation valves are tested for a full shut-off before any replacement basin is disconnected.
What the installation covers
Waste connection
Trap and rubber seal fitted so waste drains fully with no odour return.
Supply lines
Braided flexible tails connected to isolation valves for future servicing.
Mixer fitting
Single-lever or separate taps set with PTFE tape and thread compound at every joint.
Silicone sealing
Non-fungal sanitary silicone applied along the full basin perimeter to keep moisture out.
Handover test
Flow confirmed and every joint inspected for drips before the technician leaves.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Ablution basin
Other services in Salam
Bathtub installation
See the detailsJacuzzi installation
See the detailsShower cabin
See the detailsShower installation
See the detailsCommon questions
Questions about Ablution basin in Salam
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the new basin use the same pipes as the old one?
If the supply stubs and waste outlet are sound, yes. We check threads and valves first and replace only the parts that fail the check.
What if the new basin is a different size from the old one?
We measure both before removal. A different outlet position is handled with a short adapted waste connection, and any exposed tile gap is pointed out before we start.
