Isolation valves
Repair or replace main and branch isolation valves that no longer shut fully.

Jahra
Valve repair in Salmi addresses shutoff valves on main water lines serving the border area. Fluctuating pressure from a single city line causes rapid wear on cone and seat. We inspect the valve itself, clear sediment and debris, then seal and run at full pressure.
Salmi buildings are sparse and basic because of proximity to the border, and main valves are installed quickly when the city line arrives. These valves operate at unstable pressure because the line serves only a few houses and warehouses. Pressure rises and falls throughout the day, squeezing the valve cone and causing early failure. We disassemble the valve, inspect components, clean the internal passage and reassemble it with fresh flexible seals.
Salmi sits in Jahra governorate near the Kuwait-Iraq border crossing, a low-density commercial and residential area.
We measure water pressure before and after valve repair to confirm stable flow without pressure spikes.
Repair or replace main and branch isolation valves that no longer shut fully.
Fix stiff or leaking ball valves caused by scale deposits around the ball seat.
Repair broken or corroded gate valve stems common in older Kuwaiti homes.
Adjust or replace pressure-reducing valves causing fluctuating supply pressure.
Repair float valves in ground and roof tanks that overflow or fail to shut off.
Replace failed check valves that allow backflow in pump and tank feed lines.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes certainly, variable pressure stresses the cone with uneven force and distorts the seal. We replace the cone and flex rings with new parts rated to handle fluctuations.
Because one line serves only a few connections, so pressure at the valve fluctuates sharply. We select a valve with higher load rating and test it under variable pressures.
