Acoustic leak listening
Sensitive listening device pinpoints the leak behind tiles precisely.
Farwaniya
Water leak detection in Rai Industrial
Leak detection in Rai Industrial requires specialist skill because the zone has warehouses and workshops with wide roofs and massive storage tanks. We bring acoustic, thermal and pressure test tools to trace leaks in distribution pipes and roof surfaces. We map the leak source precisely before any repair action.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Warehouses and workshops in Rai Industrial have roof-mounted supply tanks and pipe networks spanning long distances between buildings. A leak from a long horizontal line may not show up for days in a hole far from the actual fault. We use the acoustic detector to hear running water directly from the pipe and measure pressure at multiple points to pinpoint the hole exactly. We then take thermal images of hot and cold pipes to isolate the leaking line from intact ones.
Rai Industrial is an industrial zone in Farwaniya near The Avenues Mall where large warehouses and commercial facilities are concentrated.
Roof leaks in Rai Industrial usually come from weak drain-line joints because roofs face intense heat and constant expansion.
What this service covers
Camera leak detection
Flexible camera enters the pipe and shows the crack or failed joint.
Non-destructive leak detection
Leak located accurately so breaking is limited to the exact fault.
Under-tile leak detection
Floor and wall leaks identified before any tiles are lifted.
Tank leak detection
Ground and roof tank inspection to find where water is being lost.
Leak repair
Faulty section repaired after location is confirmed, then line tested.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water leak detection
Other services in Rai Industrial
Sanitary technician
See the detailsTank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsCommon questions
Questions about Water leak detection in Rai Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the leak is in the roof tank, can it be repaired without draining the water?
Yes if the leak is in the lower wall section, but if it is near the top or in the lid you need to drain some water. We pinpoint the location first, then suggest the best repair option.
How long does it take to find a leak in a long distribution network?
Time depends on pipe length and signal clarity, usually one to three hours. We start at the tank and move along the line with the detector until we pick up the strongest sound.
