Ground tank survey
Locating leaks in walls and floor of a buried ground tank
Mubarak Al-Kabeer
Tank leak detection in Sabhan Industrial
Tank leak detection in Sabhan Industrial focuses on very large tanks in factories and warehouses. These metal or reinforced concrete tanks serve production, cooling and wash processes. We use pressure measurement and detection dyes to locate holes or corrosion before large volumes of water are lost.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Sabhan factories and warehouse roofs have pressurised tanks mounted on raised steel or concrete pads. These tanks carry hot water or high-speed cooling water, and even fine leaks cause significant daily water loss. We test the tank body under full pressure, monitor all joints, valves and external pipes, and use coloured water to trace the leak direction.
Sabhan Industrial is in Mubarak Al-Kabeer governorate and houses hundreds of factories and warehouses where high-pressure bulk tanks are standard.
An industrial tank losing two litres per hour under full pressure must be diagnosed the same day because production stops.
What the service covers
Roof tank check
Inspecting the roof tank body and fittings for hairline cracks
Pressure test
Controlled pressure applied to confirm and pinpoint the fault location
Acoustic listening
Probe detects the leak sound through the tank wall or surrounding tiles
Fitting and inlet check
Checking inlet, outlet and overflow fittings where leaks often start
Leak location report
Owner receives a clear finding of where and what the fault is
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank leak detection
Other services in Sabhan Industrial
Acoustic leak listening
See the detailsCamera leak detection
See the detailsLeak repair
See the detailsNon-destructive leak detection
See the detailsCommon questions
Questions about Tank leak detection in Sabhan Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can you locate a leak without shutting down the tank?
In some cases yes, if the leak is in the upper section or a visible external joint. We observe the escaping water, measure its flow and trace it. If the leak is at the tank floor, pressure must be stopped and partial draining is necessary.
Does rust on a metal tank mean it is definitely leaking?
Not necessarily. Surface rust may be from external moisture alone. But if we see deep corrosion or a pinhole, we fill and pressurize to confirm the leak and measure its rate before repair.
