Ground tank survey
Locating leaks in walls and floor of a buried ground tank
Capital
Tank leak detection in Salhiya
Tank leak detection in Salhiya focuses on careful tracing within the large tanks serving mixed commercial and residential buildings. We study the original pipe drawings and examine every joint and corner for leak signs. We pressure-test and map the problem before any repair action.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Salhiya is dense with office towers, hotels and older residential blocks sharing the same supply network, and upper tanks there often have poor insulation or are only partly covered. We climb to the roof and examine the insulation and salt deposits on outer walls. The ground tank in Salhiya may be shared by several buildings, so we trace the common pipes and old welded joints that have moved with building vibration.
Salhiya sits in Kuwait governorate near Sheraton Hotel and the Commercial Complex, where a tank leak often affects multiple residential units at the same time.
We check ground tank joints with a moisture detector at night to reduce sun glare effect and pinpoint the location more precisely.
What the service covers
Roof tank check
Inspecting the roof tank body and fittings for hairline cracks
Pressure test
Controlled pressure applied to confirm and pinpoint the fault location
Acoustic listening
Probe detects the leak sound through the tank wall or surrounding tiles
Fitting and inlet check
Checking inlet, outlet and overflow fittings where leaks often start
Leak location report
Owner receives a clear finding of where and what the fault is
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank leak detection
Other services in Salhiya
Acoustic leak listening
See the detailsCamera leak detection
See the detailsLeak repair
See the detailsNon-destructive leak detection
See the detailsCommon questions
Questions about Tank leak detection in Salhiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the tank is shared between two buildings, how do you isolate the leak from the second building's system?
We close the isolation valve between tanks and fill each separately, monitoring each for leaks. This tells us which tank is the source and which part of the pipe network needs repair without affecting the other building.
What is the difference between tank leakage and overflow valve or ball valve leakage?
We check the overflow outlet and ball valve first as they are more common sources. We observe where moisture appears: if below the outlet, the valve is the cause; if from the tank wall, the crack is in the tank itself.
