Ground tank survey
Locating leaks in walls and floor of a buried ground tank
Capital
Tank leak detection in Sawaber
Tank leak detection in Sawaber focuses on modern residential towers and massive tanks on upper floors and basements. We study the centralised supply system and multiple interconnected tanks with powerful pumps. We inspect each tank methodically and pinpoint the exact leak location before any action.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Sawaber is a complex of tall residential towers with massive horizontal tanks on roofs and vertical tanks in basements. Large tanks leak mostly from complex connections between the tank and lift pumps and multiple valves. We monitor the pressure gauges in the pump room and track pressure fluctuations that point to the leak source. Narrow vertical tanks in basements are hard to inspect inside, so we rely on pressure testing from top and bottom.
Sawaber sits in Kuwait governorate as a dense residential complex with interconnected tanks, where one leak may affect several towers at once.
We isolate each tank individually and watch the pressure gauge for one hour to identify which tank is losing pressure and the probable leak location.
What the service covers
Roof tank check
Inspecting the roof tank body and fittings for hairline cracks
Pressure test
Controlled pressure applied to confirm and pinpoint the fault location
Acoustic listening
Probe detects the leak sound through the tank wall or surrounding tiles
Fitting and inlet check
Checking inlet, outlet and overflow fittings where leaks often start
Leak location report
Owner receives a clear finding of where and what the fault is
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank leak detection
Other services in Sawaber
Acoustic leak listening
See the detailsCamera leak detection
See the detailsLeak repair
See the detailsNon-destructive leak detection
See the detailsCommon questions
Questions about Tank leak detection in Sawaber
Need someone now? The emergency line is open any hour.
+965 9668 4964
If multiple tanks are connected, how do you find which one is leaking?
We close isolation valves between tanks one by one and monitor pressure in each section. The tank whose pressure drops rapidly is the source. We then inspect its joints, floor and walls separately to locate the exact point.
Are valve and joint leaks more common than leaks in the tank walls themselves?
Yes in large modern tanks, complex connections and valves face high pressure and heat. We check joints first for water beading and thread corrosion. If joints are sound, we move to examining the tank walls themselves.
