Acoustic detection
Pinpoints the leak behind tiles before any tile is touched

Farwaniya
Stopping a pipe leak in Rehab starts by finding where moisture is coming from under walls and floors. We remove the damaged section of supply line, install new copper coupling and test pressure before covering it back.
Rehab family homes rely on roof tanks and copper distribution networks that run beneath tiles and outer walls. When a supply line leaks, water seeps under the floor and raises humidity in adjoining rooms before surface stains appear. We use a moisture meter to trace the pipe route under the foundation and open a test point near the seepage center to confirm the leak before we dig.
Rehab is in Farwaniya governorate, a family housing area where most leaks occur in long supply lines running beneath floors.
Every joint is tested at 6 bar after installation because low pressure in the network points to a leak we may have missed.
Pinpoints the leak behind tiles before any tile is touched
Films the pipe interior before and after repair work
Damaged section replaced with heat-fused pressure-rated pipe
Corroded galvanised iron replaced before internal rust causes burst
Confirms the repaired line holds before wall is closed up
Repairs leaks on roof-level supply pipes exposed to heat
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We start with a building plan if available, then check moisture with an electrical meter that reads water content in tiles and brick. We open a test point nearest the high reading to confirm the water line itself.
We lift tiles only above the pipe run until we reach the bad joint. After repair and testing, the layers under the floor dry in a few days and any lingering moisture settles on its own.
