Full diagnosis
Pinpointing the actual fault before any part is ordered

Farwaniya
Heater repair in Firdous starts by checking copper connections around the circulation pump and verifying insulation on hot pipes. We test water pressure with a gauge and monitor the thermostat to ensure the heater shuts off and restarts at the right temperatures.
Most houses in Firdous lie near Sixth Ring Road, with heaters mounted in small rooms or exposed rear balconies facing the elements. Outdoor piping loses insulation because of intense heat and ultraviolet exposure, cutting efficiency and raising heat loss. We disassemble semi-rigid pipes, wrap them in fresh 25 mm insulation and seal the ends against water seepage.
Firdous in Farwaniya governorate is a medium-density residential zone near a main highway, where heaters face sharp outdoor temperature swings.
After fitting fresh insulation we run the heater through a full cycle from cold to warm to check diverter valve action and pressure.
Pinpointing the actual fault before any part is ordered
Checking every water, gas and electrical connection at the unit
Confirming the unit reaches and holds its target temperature
Verifying gas heater ventilation is safe after every service
Tracing leaks acoustically and visually without random breaking
Advising the owner on the unit's condition and future needs
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, water seeps between the wraps and reaches metal joints causing rust that clogs valves. We remove wet insulation completely, let pipes dry for hours, then wrap fresh insulation with a tight seal.
If the pump makes a clicking noise or pressure drops despite opening all taps, the pump may be worn. We test flow and measure pressure first, and if the reading is below 1.5 bar we recommend pump replacement.
