Main line jetting
High-pressure water drives grease and sediment out of the main sewer run
Ahmadi
High-pressure jetting in Shuaiba
High-pressure jetting in Shuaiba starts by opening a street trap or front courtyard trap and inserting a camera probe to pinpoint the blockage precisely. We bring a large-tanker jetter because this industrial zone's lines are long and carry heavy deposits. Water at 280 bar removes industrial grease, sediment and silt buildup. Once finished, we camera the line again to confirm it is fully clear.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba is a mixed industrial and residential zone with factories, warehouses and older apartment blocks, lines running from these buildings to the main outlet under the street. Grease from industrial kitchens and food factories enters pipes and builds with mineral scale and silt from used water. Blockages happen fast, especially in hot summer. Old pipes may be ceramic or early plastic and might crack under strong pressure so we test pressure carefully. High pressure breaks heavy grease layers effectively.
Shuaiba is in Ahmadi governorate, an industrial and residential port area south of Ahmadi.
We camera pipes before pressure because old pipes here may be cracked from years of heavy use.
What the jetting service covers
Kitchen line cleaning
Cuts through congealed oil layers that narrow the pipe wall over time
Manhole and gully jetting
Flushes accumulated sand and debris from inspection chambers and gullies
Pre-jetting camera check
Camera locates the blockage type and position before any jetting starts
Post-clear camera check
Camera confirms the pipe is fully clear; customer views the same screen
Commercial building networks
Adjusted pressure for longer pipe networks in complexes and restaurants
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for High-pressure jetting
Other services in Shuaiba
Bathroom drain unblocking
See the detailsDrain snake unblocking
See the detailsKitchen drain unblocking
See the detailsMachine unblocking
See the detailsCommon questions
Questions about High-pressure jetting in Shuaiba
Need someone now? The emergency line is open any hour.
+965 9668 4964
Are food factory greases harder to clear than kitchen grease?
Yes, industrial greases are thicker and set hard especially in winter and need higher pressure and may need a second pass. We raise pressure gradually to avoid damaging old pipes.
How often should lines serving factories in Shuaiba be jetted?
Every three to six months depending on grease load. Some factories need monthly jetting if production is high. We recommend regular scheduled jetting to avoid sudden blockages that could halt production.
