Blocked outlet clearing
Removing sand and silt blocking storm-water outlet pipes
Hawalli
Storm-water drainage in Ministries Area
Rain water drainage in the Ministries Area demands clear understanding of deep foundations and wide roof surfaces on government buildings. We inspect existing lines, clear sediment, test falls and design improvements to stop water pooling around formal entrances.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Government buildings in the Ministries Area have vast flat roofs and large courtyards that must shed rainwater quickly before it pools. Underground, the deep footings of massive structures confine new drain lines to tight gaps between columns and perimeter walls. We open roofs at multiple points to test existing pipes and measure sediment buildup, then decide whether full cleaning is needed or replacement with larger-bore runs.
The Ministries Area lies in Hawalli near the Government Ministries Complex, a densely built zone where rainwater systems must handle peak loads.
We test every pipe section gradient with water level because large roofs generate high flow within minutes.
What the service covers
High-pressure line jetting
Water jet cuts through compacted sand and dried silt inside the line
Pre and post camera check
Internal filming before and after so the clear result is confirmed
Storm-drain network design
New network laid to correct falls for the property footprint
Sump and gully cleaning
Emptying and cleaning collection sumps and linked floor gullies
Scheduled network maintenance
Pre-season visits to keep storm lines clear before rain arrives
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Storm-water drainage
Other services in Ministries Area
Manhole and inspection chamber cleaning
See the detailsRestaurant grease traps
See the detailsSewerage contracting
See the detailsSewage tanker and suction
See the detailsCommon questions
Questions about Storm-water drainage in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you know if existing pipes can handle heavy rain?
We open access points and check sediment, leaves and debris inside. If blockage exceeds half the pipe diameter, peak flows cannot drain and pooling will occur.
Can new lines be run without deep digging under the building?
Usually yes, we run new lines through gaps between columns or along exterior walls and connect to a main collector nearby. Deep digging only happens if the run is very long or gradient is insufficient.
