Pipe routing
Mapping every copper run before walls are plastered over

Ahmadi
Gas network setup in Hadiya starts from the pressure meter on the house's external wall and branches in copper to the heater, cooktop and other appliances. Before completion we test pressure and flow and verify every valve moves freely.
Hadiya has villas and apartments around Ahmadi Town, many with central heating systems needing steady gas supply and constant pressure. Pipe runs from the meter on the external wall and enters the house through a sealed opening then branches to the boiler room and kitchen. We check the fall on each section to prevent condensation pooling, and mark the entry point in red paint so fibreglass finish does not cover it.
Hadiya sits near Ahmadi Town in Ahmadi governorate, where older and newer residential units stand together.
After completion we test the network with an air void along each branch to detect any blockage before actual gas is supplied.
Mapping every copper run before walls are plastered over
Branching the network to each appliance position per plan
Fitting an isolation valve at every outlet for future servicing
Dry nitrogen charge and pressure hold test before handover
Core drilling wall openings and securing pipes with correct clips
Recording final pipe routes for future maintenance reference
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We use a copper ferrule and rubber washer at the entry point, then seal the opening with flexible sealant that does not harden in cold. This lets the pipe move slightly without cracking.
No, the main valve stays outside at the meter for safety reasons. But we install a secondary stop-cock near the kitchen entry so gas to appliances can be cut quickly.
