Pipe routing
Mapping every copper run before walls are plastered over

Jahra
Central gas network installation in Uyoun starts from the meter at the entry and runs to every hob and water-heater before plastering begins. We lay copper tubing horizontally under the ceiling and vertically inside walls, inspecting every joint under pressure. The work finishes before final finishes start.
Houses in Uyoun built near the natural springs have raised foundations and standard wall thickness. We open straight runs from the meter room to the kitchen, main bathroom and majlis. Each branch is tested with a hand pump at nine bar to confirm no joint leaks before plastering covers the work.
Uyoun lies in Jahra governorate, known for natural water springs, a residential area of modern family homes surrounded by irrigated gardens.
The full network is pressurized to nine bar for thirty minutes before any run is covered because reopening plastered walls is costly.
Mapping every copper run before walls are plastered over
Branching the network to each appliance position per plan
Fitting an isolation valve at every outlet for future servicing
Dry nitrogen charge and pressure hold test before handover
Core drilling wall openings and securing pipes with correct clips
Recording final pipe routes for future maintenance reference
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We use soldered copper couplings and Teflon tape plus heat-resistant compound on every male thread. After assembly, we check with soapy water for any bubbles before covering.
We leave spare branches capped with brass plugs from the distribution point, so a new cooker can be connected later without altering the main runs. The caps are tested at the same pressure as the network.
