Electronic detection
sensors detect escaping gas through walls without any breaking
Farwaniya
Gas leak detection in Abraq Khitan
Gas leak detection in Abraq Khitan focuses on pipes running through gaps between blocks and adjoining houses. We inspect joints at corners, ceilings and shared floors for slow leaks, and use soap solution to confirm any doubt before disconnecting and re-sealing the pipe.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Abraq Khitan has crowded residential blocks and small houses built very close together, with gas pipes running through narrow gaps between shared walls and ceilings. Many joints in Abraq Khitan are threaded and held by metal clips only without modern sealing sleeves. We inspect each threaded joint with a special wrench and look whether the pipe outer thread is visible or covered in grease and corrosion. If the joint is loose we tighten it, and if leaking reappears after tightening we disassemble and re-seal with quality tape.
Abraq Khitan is a Farwaniya residential area marked by high building density and tight gaps between structures.
We tighten each threaded joint with precise calibrated force that does not strip the delicate threads of copper and nickel pipes.
What this service covers
Pressure test
network segments isolated and pressure drop measured to find the faulty section
Joint inspection
every joint and valve checked with leak-detection fluid where leakage is suspected
Source isolation
gas isolated to the faulty section immediately to keep the building safe
Line repair
only the damaged section repaired or replaced, rest of network left intact
Final pressure check
full pressure test after repair confirms the entire network is tight
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Gas leak detection
Other services in Abraq Khitan
Kitchen gas lines
See the detailsRestaurant gas lines
See the detailsCentral gas first-fix
See the detailsPlumbing installations
See the detailsCommon questions
Questions about Gas leak detection in Abraq Khitan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do tight gaps between blocks make repair very difficult?
Yes, two people cannot work together in the gap, but we can reach with one pipe and small tools. It takes longer but the result is just as solid and safe.
Do pipe joints in Abraq Khitan need regular routine checks?
Yes, because threaded joints loosen with vibration and thermal expansion. We recommend annual checks using soap solution at every visible joint, and if tiny bubbles appear we tighten the pipe right away.
