Plumbing and electrics first-fix
Coordinating pipe and conduit routes before walls are closed
Hawalli
First-fix plumbing for new houses in Ministries Area
First-fix plumbing in the Ministries Area demands precise layout because government buildings need complex drainage and supply networks serving many floors. We run cold water, hot water and waste lines before wall closure, then pressure-test each section with compressed air to confirm no leaks. We document all pipe routes on site drawings so maintenance teams find them easily later.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Large administrative buildings near the Civil Service Commission share similar traits: a main drainage stack dropping from roof level, and a central supply riser branching to departments. We must locate inspection points on each floor before concrete pours, because adding them later breaks the structure. We calculate long vertical falls with partial horizontal runs to keep drainage steady, and coordinate with other plumbers if offices and flats are leased independently.
The Ministries Area lies in Hawalli near the central government complex, an administrative zone where pipes run hidden within multi-storey walls and floors.
We test every drainage branch at 3 bar air pressure for 15 minutes before floor handover because fixing leaks after wall closure means breaking out entire partitions.
What first-fix plumbing covers
Bathroom first-fix
Hot, cold and waste lines run to every sanitary point
Kitchen first-fix
Supply for sink, appliances and gas line inside the structure
Apartment first-fix
Full pipe runs per unit including meter point positions
Drainage first-fix
Drain lines laid to correct falls with proper vent stacks
Tanks and pump connections
Ground and roof tank connections integrated during structural stage
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for First-fix plumbing for new houses
Other services in Ministries Area
Low water pressure
See the detailsMixer and faucet repair
See the detailsPlumbing installations
See the detailsPlumbing maintenance contracts
See the detailsCommon questions
Questions about First-fix plumbing for new houses in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How can we be sure hidden pipes won't leak after years?
Before closure we fill the pipes with clean water and watch for 24 hours to detect pressure drop. We clean and dry every joint before final assembly and testing. This ensures no moisture inside pipes causes corrosion later.
What if one department later needs pipes rerouted?
We install isolation valves and stop-points at each department's entry so supply can be cut without affecting others. We leave spare empty conduits in walls to make rerouting easier without breaking structures.
