Pressure diagnosis
Pressure measured at multiple points to pinpoint exactly where the fault lies
Jahra
Low water pressure in Mutlaa
Treating low pressure in Mutlaa starts with measuring pump station output and entry pressure at each house on the ridge. The area's natural elevation increases pipe load and cuts pressure, so we calculate expected loss, test hydraulic valves and filters.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Mutlaa houses stand on elevated ground, meaning each metre of rise cuts pressure by roughly 0.1 bar. A house 100 metres above the pump station loses around 10 bar of pressure. We install a pressure gauge at house entry, use GPS to measure elevation, then choose pipe diameter large enough to reduce resistance. Sometimes we fit a pressure regulator that holds steady pressure despite height changes.
Mutlaa sits in Jahra governorate at the highest point in northern Kuwait, where elevation directly affects water network performance.
We measure the house's actual elevation above sea level and subtract the pressure loss from height from original inlet pressure.
What this service covers
Pump and pressure switch
Transfer pump, pressure switch and expansion vessel checked and set correctly
Scale removal
Mineral scale cleared from pipes, pressure reducers and aerators blocking flow
Pressure regulator
Pressure-reducing valve inspected, adjusted or replaced if it restricts supply
Tank and feed check
Tank level, float valve and inlet pipe verified to rule out supply shortfall
Final pressure test
Pressure confirmed at all outlets after repair before the visit closes
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Low water pressure
Other services in Mutlaa
First-fix plumbing for new houses
See the detailsMixer and faucet repair
See the detailsPlumbing installations
See the detailsPlumbing maintenance contracts
See the detailsCommon questions
Questions about Low water pressure in Mutlaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is there a minimum pressure that water must reach in Mutlaa?
Yes, 1.5 bar minimum for a normal household shower and 2 bar for a washing machine. At extreme elevations the mains alone cannot reach this, so we recommend a storage tank that fills slowly at night.
Does a pressure regulator valve need regular maintenance?
Yes, inspect every six months to clean the internal screen and verify the setting has not shifted from vibration or moisture. We test pressure after cleaning to confirm it maintains your original setting.
