Pressure diagnosis
Pressure measured at multiple points to pinpoint exactly where the fault lies
Ahmadi
Low water pressure in Shuaiba
Diagnosing low pressure in Shuaiba takes extra time because the main pipes run underground across long distances in the industrial area. We measure pressure at the street inlet and then at the first tap inside the building. From there we inspect valves, filters and tank to determine if the problem is in the main line or the internal network.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba is an industrial port zone of Ahmadi with shared water supply lines between several facilities. Pipes underground may be stressed by excavation and heavy vehicles and can crack or dent inward. Many buildings here also have large roof tanks and risers of varying diameters that may cause pressure variation between floors. We sweep the main pipes for partial collapse and verify tank filling rate.
Shuaiba is an industrial port in Ahmadi governorate south of the city, where main pipes are exposed to environmental stresses from industrial operations.
An acoustic detector is used to locate cracks in buried pipes before resorting to excavation.
What this service covers
Pump and pressure switch
Transfer pump, pressure switch and expansion vessel checked and set correctly
Scale removal
Mineral scale cleared from pipes, pressure reducers and aerators blocking flow
Pressure regulator
Pressure-reducing valve inspected, adjusted or replaced if it restricts supply
Tank and feed check
Tank level, float valve and inlet pipe verified to rule out supply shortfall
Final pressure test
Pressure confirmed at all outlets after repair before the visit closes
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Low water pressure
Other services in Shuaiba
First-fix plumbing for new houses
See the detailsMixer and faucet repair
See the detailsPlumbing installations
See the detailsPlumbing maintenance contracts
See the detailsCommon questions
Questions about Low water pressure in Shuaiba
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is low pressure in Shuaiba because of the long distance from the pumping station?
Distance has some effect but high pressure in the mains usually compensates. We measure street pressure first to know if the source is weak or the indoor network is blocked.
Does finding a broken pipe require large excavation holes?
The acoustic detector pinpoints the exact location very closely and we dig only a small hole to see the problem. Then we seal the crack with epoxy or cut and install a new coupling depending on damage size.
