Pressure diagnosis
Pressure measured at multiple points to pinpoint exactly where the fault lies
Capital
Low water pressure in Yarmouk
Weak water pressure in Yarmouk requires a thorough check from the street to the last tap in the home. We inspect the main inlet pipe, stopcock, filter and branch pipes distributed inside. We test pressure at each point to pinpoint exactly where pressure is lost.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Yarmouk villas are relatively modern but many have complex distribution pipe runs passing under several floors with sharp bends that slow flow. Floor and wall pipes that are too narrow or convoluted block water more than straight runs. Measuring the original pipe diameter and its location under concrete structure helps us suggest a fix without breaking concrete.
Yarmouk sits in Kuwait governorate near Yarmouk Co-op and Yarmouk Sports Club, a district of modern villas.
A blocked pipe in the first meter from entry cuts water flow more than a blockage at the far end of the line.
What this service covers
Pump and pressure switch
Transfer pump, pressure switch and expansion vessel checked and set correctly
Scale removal
Mineral scale cleared from pipes, pressure reducers and aerators blocking flow
Pressure regulator
Pressure-reducing valve inspected, adjusted or replaced if it restricts supply
Tank and feed check
Tank level, float valve and inlet pipe verified to rule out supply shortfall
Final pressure test
Pressure confirmed at all outlets after repair before the visit closes
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Low water pressure
Other services in Yarmouk
First-fix plumbing for new houses
See the detailsMixer and faucet repair
See the detailsPlumbing installations
See the detailsPlumbing maintenance contracts
See the detailsCommon questions
Questions about Low water pressure in Yarmouk
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can blocked pipes be cleaned without breaking up the floors?
Yes, if the blockage is small we use a spiral drill tool or high-pressure flush to clean the pipe from inside. If this fails we may run a temporary feed line above floor while later construction work is planned.
Why is pressure strong at the bar tap but weak at kitchen and bathroom taps?
This means kitchen and bathroom pipes are partially blocked while pipes near the entry are clear. We open suspect pipes and clean or replace them with clean ones. Test the isolation valves for weak zones too as they may be closed tight.
