Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Farwaniya
Mixer repair in Abbasiya usually means a leaking handle where water drips slowly even when fully closed. We inspect the ball valve or cartridge, replace worn parts and show the user the proper closing technique.
Apartments in Abbasiya are compact with small bathrooms where wall-mounted mixers sit flush without worktops, making it easy to check the pipes behind. When a mixer leaks from the base we often find the copper tube has bent slightly and pinched the seal. We carefully straighten the tube, test the joint and refit the trim ring.
Abbasiya is in Farwaniya governorate and contains dense apartment blocks with compact bathrooms.
We check the incoming water pressure before starting because high pressure wears seals much faster.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Very rarely. Base leaks come from worn seals or a slight bend in the tube pinching the seal. We inspect the tube visually first and if there is no crack the fault is definitely in the mixer itself.
Tightening the nut may stop the leak temporarily but it crushes the seal and wears it faster. The right fix is to open the handle and replace the internal seal.
