Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Capital
Mixer and faucet repair in Dasma
Mixer repair in Dasma starts with precise diagnosis before any part replacement. We inspect internal seals, rubber washers, springs and supply lines to identify the real cause of dripping, weak flow or locking. We fix the mixer rather than replace it entirely where possible, keeping your existing fitting. Before leaving, we test flow, mixing and drainage under normal pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most apartments in Dasma were built decades ago with simple single or dual-handle mixers, and these fittings need regular service because Dasma water is mineral-rich. We descale filter heads and replace worn washers and springs without lifting the mixer from its seat. Some units have old copper pipework with variable pressure, so we test pressure first to avoid breaking any joint during work.
Dasma sits in Kuwait City and is known for established residential buildings near the East area, where installed mixers need specialist care.
Every mixer is tested by running hot and cold together and checking each joint for leaks because moisture in small Dasma kitchens shows problems quickly.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Dasma
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Dasma
Need someone now? The emergency line is open any hour.
+965 9668 4964
My mixer drips constantly from underneath, does it need full replacement?
Usually no; dripping from below means the rubber washers under the handle have worn out. We disassemble the mixer internally, replace the washers and springs, then reassemble and test.
Cold water sometimes comes out hot without warning, why does this happen?
This happens when the internal selector valves fail or hot water enters the cold line. We trace the line from the overhead tank to the mixer and fix the valve that is not shutting completely.
