Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Hawalli
Mixer repair in Hawalli covers shops, clinics and offices as well as homes, where heavy use wears seals quickly. We check the open-close cycle frequency and improper hot water and high-pressure use. We fit industrial-strength seals and test the mixer under full load before handover.
The commercial Hawalli strip near Hawalli Co-op and the Red Crescent Society contains a mix of industrial and domestic mixers suffering from intensive use. Mixers in restaurants and clinics open and close hundreds of times daily, destroying seals and valves. We fit reinforced seals and lubricate valves with medical-grade olive oil to reduce friction. We clean ports of grease and metal particles after each repair.
Hawalli is known for its commercial shops and medical clinics, where mixers bear daily pressure much greater than ordinary homes.
We test the mixer after repair through dozens of rapid open-close cycles because weak valves may fail under heavy use.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
At least every six months, because heavy use accelerates seal wear. We inspect without waiting for leaks and replace weak seals and valves before complete failure.
Yes, but not all industrial mixers installed in shops are reliable. Some are cheap and flawed. We replace seals with military-grade types if needed and lubricate valves with friction-reducing materials.
