Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Ahmadi
Mixer repair in Jaber Al-Ali requires understanding the slow drips and pressure fluctuations common here. We measure hot and cold at source before the mixer then trace the exact fault point. The right fix flows with full balance and no leaks from any seat.
Jaber Al-Ali has medium houses with tight kitchens and mixers set precisely on thin tile walls. Older mixers age differently than new ones because internal seals harden from continuous hot water. We check the wall-mounted mixer for slight slippage in fittings, which can cause uneven pressure in the handle. We focus on connection points between the supply pipe and internal cavity where mineral salt cracks occur.
Jaber Al-Ali sits in Ahmadi governorate, a multi-storey residential area served by unified water from a central tank.
Before leaving we run the mixer at half flow for thirty minutes to verify steady pressure without fluctuation.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Metal mixers warm from hot water flowing inside, which is normal but should not be uncomfortable. We check that water is not leaking from joints and wrap insulation tape round internal tubes if needed.
Often it is trapped air in the hot water pipes underground, especially after service interruptions. We open the air valve on the handle or the supply tubes to release air regularly.
