Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Capital
Mixer and faucet repair in Qortuba
Mixer repair in Qortuba starts by finding what is actually wrong before buying spare parts. The faucet might leak from the spray head, from its base, or the hot water supply may be blocked. We disassemble the mixer, check the connections, internal inlet and rubber seals, and fix only the real fault.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most older Qortuba villas have brass or steel cartridge mixers that need regular upkeep because mineral scale builds up in the inlet. When we open the mixer we find white deposits around the narrow channel where hot and cold water meets. We clean the scale with neutral descaler and test flow in both directions before reassembling the body.
Qortuba sits in Kuwait governorate, an upscale villa zone where distribution pipes run internal and drainage is confined beneath the structure.
Every mixer is checked after repair under full pressure for five minutes because slow leaks only show after time.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Qortuba
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Qortuba
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can an old mixer be repaired instead of replaced entirely?
Yes, if the outer connections and brass body are intact. We replace only the hot and cold water seals and the internal cartridge, which costs less than buying a new mixer. An old mixer after servicing performs like new.
Why does cold water come out hot from the mixer even when I open only the cold tap?
Hot and cold pipes run side by side under your floor, and heat transfers from the hot line to the cold. We reduce this by insulating the pipes or letting a short pause pass before use. If the mixer is new, the cartridge may have a small defect letting hot water enter the cold outlet.
