Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Hawalli
Mixer and faucet repair in Salwa
Mixer repair in Salwa typically starts by checking the shutoff valve area under the sink for leaks or no flow. We disassemble the head or cartridge, inspect seals and limescale buildup and replace only the damaged parts. Then we test temperature and flow before handing over.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Salwa houses are older with horizontal copper pipes under kitchens and bathrooms, and their mixers often suffer weak flow from limescale deposits. We remove the mixer carefully from its connections, clean the screens and internal inlet, and if the cartridge is worn we replace it with an original part matching the model. We watch the order of seal rings when reassembling because a mistake causes a slow leak later.
Salwa sits in Hawalli governorate near Salwa Co-op, a family residential area with kitchens and bathrooms fitted with mixers that are twenty years old or older.
After assembly the mixer is tested by running cold and hot water together to ensure even blending and no leaks from seals.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Salwa
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Salwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why is hot water very weak but cold flow is normal?
Usually the hot line carries more limescale deposits than the cold. We open the main hot water valve and flush the line before inspecting the mixer itself.
Does the entire mixer need replacing or is internal cleaning enough?
If the cartridge is intact and seals are still supple, cleaning alone is enough and saves money. We remove deposits and refit the original rubber seals.
