Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Jahra
Faucet repair in Uyoun starts by seeing where the leak is: the spout, the body base, or the pipes under the sink. We disassemble the mixer carefully, check seals, spindles and valves, replace only what is actually damaged and test pressure and flow before we finish.
Uyoun is near natural springs, and many houses and farms there have exposed mixers on yard walls and ground-tank enclosures, where hard mineral water leaves lime deposits in aerators and valves. We check the spout aerator first and gently remove scale, then test pressure in each direction before reassembling, because an outdoor mixer needs more regular maintenance than an indoor one.
Uyoun lies in Jahra governorate near natural springs, where water is drawn from deep mineral-rich wells.
We test every repaired mixer under full pressure for one minute because slow seeps under load show up in daily use.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Dripping after closure means the internal shut-off valve is worn or the seal is not seating correctly. We disassemble the spout head, replace the valve or clean the seal seat and test the closure.
If the pipes and body are sound we replace only the internal parts and it runs for years more. If the body is cracked or pipes are pitted we recommend replacement.
