Operation and maintenance contract
Scheduled agreement that sets visit frequency and inspection scope.
Jahra
Operation and maintenance contracts in Mutlaa
Network maintenance in Mutlaa handles very high pressures on pipes that rise and fall with the terrain. We inspect pumps, shutoffs and hung tanks monthly and measure pressure at the highest and lowest points. The ridge location means pressure loss accelerates fast if even small cracks develop.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Houses and facilities in Mutlaa are spread across the hillside with large height differences between the water inlet and upper flats. Pipes work under very high pressure to push water upward, and this stress strains joints and valves. We check the pressure reducer in every house because excess pressure cracks flexible pipes and shutoffs. Every three months we disassemble the air valves at the top of tanks above Mutlaa to remove deposits.
Mutlaa sits in Jahra governorate, an elevated ridge zone where height differences multiply hydraulic pressure on networks.
Pressure at the lowest point in Mutlaa sometimes exceeds eight bar because thermal expansion in pipes raises it.
What the contract covers
Supply network inspection
Pressure readings and pipe condition checks for scale and corrosion.
Drainage network follow-up
Tracing drain flow and clearing grease traps and outlets before blockage.
Leak detection rounds
Acoustic listening and meter reading to catch hidden wall leaks early.
Pumps and tanks
Checking transfer and pressure pumps and ground and roof tanks.
Visit reports
Written document after every visit listing condition findings and recommendations.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Operation and maintenance contracts
Other services in Mutlaa
Building and complex maintenance
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Operation and maintenance contracts in Mutlaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can high pressure crack new copper pipes on the ridge?
Yes if pressure exceeds the pipe rating. We fit a pressure reducer at the house inlet to drop it to six bar. We check it monthly because water freezing inside can break it.
Why does a tank on the ridge need a strong air valve?
High pressure prevents air entering the tank during pumping. The air valve lets air escape then closes before the level drops. If it clogs, a vacuum forms inside that stops pumping completely.
