Washbasin and wall-hung basin
Countertop or wall-hung, with supply lines and a sealed waste trap.
Farwaniya
Sanitary fixture installation in Sabah Al-Nasser
Sanitary fixture installation in Sabah Al-Nasser accounts for most homes being relatively new with standard drain systems. We first map the pipe route on plans, then verify the actual site. Connections are run precisely and pressure and leak tests are done before walls close.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Villas and apartment blocks in Sabah Al-Nasser are closely spaced along the Sixth Ring Road, meaning pipes beneath slabs are crowded and working space is tight. We navigate this constraint carefully to avoid breaching other pipes or electrical cables. Main pipes in most homes are rigid PVC plastic 4 inches in diameter with straightforward connections easy to repair if needed.
Sabah Al-Nasser sits in Farwaniya governorate along the Sixth Ring Road, a modern high-density residential zone.
Every plastic joint is tested by running cold water at 6 bar pressure for 10 minutes immediately after installation.
Fixtures we install
Ablution basin
Wall or counter mount with correct waste outlet and supply valves.
Western and wall-hung toilet
Pan, cistern or in-wall frame, sealed base and flush line fitted correctly.
Shower cabin and shower installation
Tray, linear drain, riser and mixer connected and water-tested before tiling.
Bathtub installation
Set level, overflow solvent-welded, mixer and waste fully connected.
Jacuzzi installation
Supply, pump and jet lines connected with pressure test before finishing.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Sanitary fixture installation
Other services in Sabah Al-Nasser
Water leak detection
See the detailsWater pipe runs
See the detailsWater pump install and service
See the detailsWater tank installation
See the detailsCommon questions
Questions about Sanitary fixture installation in Sabah Al-Nasser
Need someone now? The emergency line is open any hour.
+965 9668 4964
If existing pipes are PVC, can new copper pipes be connected to them?
Yes using a brass adapter between the two types, but we prefer matching pipe materials in each home to avoid corrosion. If the existing line is PVC we run new PVC in the same diameter with matching joints.
How long does it take to install three complete bathrooms in one villa?
Usually 3 to 4 working days, depending on whether pipes already exist or must be run from scratch. We start by routing, then fix the pipes, then install fixtures and do final testing.
