Waste outlet check
Height and position confirmed before the shower tray is set.
Hawalli
Shower installation in Bidaa
A Bidaa shower requires checking walls and existing drainage in flat bathrooms near Salmiya seafront. We choose the correct head height, run pipes at steady slope, seal joints with moisture-resistant compound before testing.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Bidaa is a moderately dense residential area close to Salmiya seafront with relatively modern flats having square bathrooms and tiled walls. Shower installation here requires precise slope from head to floor trap because any wall irregularity traps water. We measure the floor's natural slope first and add sand and base layer under tiles if needed to ensure proper flow without drain blockage.
Bidaa is in Hawalli governorate near Salmiya seafront, where high humidity calls for strong water-resistant sealing in new shower installations.
The new shower is tested at maximum pressure for two minutes before handover to confirm there are no leaks.
What the installation covers
Tray and trap fitting
Tray levelled and trap sealed with a rubber gasket.
Supply line connection
Hot and cold lines connected to the mixer with isolation valves.
Mixer and head fitting
Mixer and arm fitted with thread sealant on every joint.
Silicone edge sealing
All tray-to-wall edges sealed with non-fungal sanitary silicone.
Flow and leak test
Water run and full drainage confirmed before handover.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Shower installation
Other services in Bidaa
Shower cabin
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Shower installation in Bidaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does coastal humidity cause rapid corrosion of metal shower pipes?
Yes, sea salt and humidity accelerate corrosion especially on metal joints. We use copper or chrome-plated pipes that better resist salt and apply extra protective coating to all connections.
What stops water seeping through bathroom walls after a new shower is fitted?
We use epoxy waterproofing under tiles along the new waste run and around the shower head base. We apply three coats on the wall from floor to one metre above the head because coastal moisture can seep through tiny gaps.
