Position and height
correct mounting height marked before any fixing begins

Farwaniya
A well-fitted basin in Ardhiya requires calculation of distances from the main supply line and drain. We choose a height suited to the existing bathroom and run pipes with correct fall throughout. Every joint is tested with hot and cold water before completion.
Homes and villas in Ardhiya sit near an industrial zone, so main lines may be old or heavily used by multiple units. We inspect the water main to gauge available flow pressure. If pressure drops when other taps run, we fit a backup tank or vacuum valve to balance flow.
Ardhiya lies in Farwaniya governorate near the industrial zone, where most homes face water pressure challenges.
Water pressure at the connection point is measured with a gauge before and after the basin is fitted.
correct mounting height marked before any fixing begins
drain slope set and trap fitted with a proper water seal
hot and cold supply connected through new isolation valves
sanitary silicone applied at the basin edge to block water ingress
mixer seated and cartridge aligned to stop dripping at rest
water run and every joint checked before wall or cabinet is closed
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, below half bar pressure the flow becomes too weak. We test pressure first and suggest a backup tank or vacuum valve before installation if needed.
Not always, but we run water through them to check flow and leaks. If they are too narrow or heavily corroded we replace part of the main line with new pipe.
