Position and height
correct mounting height marked before any fixing begins

Hawalli
A new washbasin in Nuqra typically requires a quick connection from existing supply and waste pipes. We choose a location close to the outer wall to minimise cutting and test pressure and flow precisely.
Old Nuqra houses have thick stone and concrete walls, and their pipe networks are aged but sound. When tracing an existing feed we may find pipes of different ages joined with old fittings. We measure pressure before making a new connection and inspect existing joints for slow leaks, as floors may hide problems needing repair.
Nuqra sits in Hawalli governorate near Salmiya, a historic area with older apartment blocks and some newer houses.
We run new pipes and leave a half-centimetre gap at fittings to allow natural seating before tightening permanently.
correct mounting height marked before any fixing begins
drain slope set and trap fitted with a proper water seal
hot and cold supply connected through new isolation valves
sanitary silicone applied at the basin edge to block water ingress
mixer seated and cartridge aligned to stop dripping at rest
water run and every joint checked before wall or cabinet is closed
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
If existing pipes hold pressure without leaks we can draw from them directly. We pressure-test them for several minutes before the new connection, and if we find leaks we suggest partial or full replacement.
We measure the existing fall before planning the waste run. If the gradient is adequate we carefully lay the pipe under old tiles. If it is insufficient we suggest raising part of the floor or using a wall-hung basin with a higher outlet.
