Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs

Jahra
Plumbing repair in Sulaibiya often starts with a villa owner calling to say water is leaking from a brass fitting under the sink. We arrive quickly, unscrew the fitting, inspect the thread and compression nut, and test the flow before leaving.
Houses scattered across Sulaibiya rely on surface roof tanks and brass pipes running through sandy foundations. Leaks at joints are the most common fault because intense heat weakens threads and compression nuts. We clean the thread with a wire brush before wrapping tape and hand-tightening the fitting, because over-tightening cracks thin brass.
Sulaibiya sits in Jahra governorate, a desert area inhabited by villa owners and small-scale farmers.
Every joint is tested by closing the tap and watching pressure for one minute because weak joints leak immediately.
PPR, uPVC and corroded galvanised iron joints and runs
repair or replacement of leaking or stiff mixers and isolation valves
tracing low pressure to scale buildup, a blocked aerator or a pump fault
fitting toilets, cisterns, basins and floor drains correctly and leak-free
pressure test on the line after every repair before closing the wall
locating the exact fault before any decision to break or repair
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Extreme heat and daily expansion stress the thread and compression nut quickly. We use thick PTFE tape and hand-tighten only to avoid cracking the brass.
Not always. If the leak is below the water line we shut the tap before unscrewing. If it is above the water line we drain only part of the tank.
