Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs
What a sabbak handles
pipe joints, fixtures, valves and pump faults in homes, apartments and commercial buildings
Mixers and valves
repair or replacement of leaking or stiff mixers and isolation valves
Water pressure
tracing low pressure to scale buildup, a blocked aerator or a pump fault
Fixture installation
fitting toilets, cisterns, basins and floor drains correctly and leak-free
Post-repair check
pressure test on the line after every repair before closing the wall
Fault diagnosis
locating the exact fault before any decision to break or repair
How the job runs
Call or WhatsApp
describe the fault and its location and we arrange a visit
On-site diagnosis
the sabbak checks symptoms and pinpoints the exact fault source
Repair plan
repair method and any breaking requirement agreed before work starts
Carry out repair
fault fixed using the agreed method and appropriate materials
Test and handover
line pressure tested and confirmed leak-free before leaving the site
Signs you need a sabbak
Unexplained damp patch
a damp wall, lifted tile or ceiling stain with no visible source points to a hidden pipe leak
Sudden pressure drop
weak flow at one or more taps while the tank is full often means scale narrowing a pipe or valve
Noise inside the wall
a persistent dripping or humming behind a finished wall points to a loose joint or failing valve
Higher water bill
a water bill that climbs without any change in usage is an early sign of a continuous pipe leak
Before you call
Locate the main stopcock
know where the main isolation valve is so you can shut off the supply immediately if needed
Note the exact location
record which room, wall or fixture shows the fault so the sabbak arrives prepared for it
Check the water meter
close all taps and read the meter; if the dial still moves there is an active leak in the line
Document the symptoms
photograph the damp area or fault and note when it first appeared to speed up diagnosis on arrival
More in sanitary technician
24-hour emergency plumber
See the details
Master plumber
See the detailsPart of Sanitary technician · All services · Back to the home page
What decides the price
no fixed rate applies; the quote depends on several factors specific to the fault and the work required
Type of repair
replacing a joint differs from tracing a leak behind a tiled finished wall
Pipe material
old galvanised iron needs different parts and more labour than PPR or uPVC
Breaking and reinstatement
if tile breaking is necessary the cost varies with the area that must be opened
Fault location
a fault in an open bathroom is faster and cheaper than one buried in a slab or ceiling
Building type
large villas and building complexes require more time and different equipment than single apartments
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Sanitary fixture installation
- Cistern and mixer repair
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Water pipe leak repair
Restaurants
- Restaurant gas lines
- Gas leak detection
- Kitchen plumbing runs
- Water pump install and service
Complexes and buildings
- Building and complex maintenance
- Roof tank and basement pumps
- Water tank installation
- Operation and maintenance contracts
Why us
Why Al Amana for plumber (sabbak)
Amana means trust. Someone else’s home is not ours to be careless in.
Photographed before and after
Do not take our word for it. Look at the work yourself.
We find it before we break it
The leak is marked before a single tile comes up.
24-hour emergency
A leak does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
We cover all of Kuwait
Six governorates, 139 areas.
CapitalHawalliFarwaniyaAhmadiMubarak Al-KabeerJahra
Common questions
Questions about plumber (sabbak)
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a pipe leak behind finished tiles be fixed without breaking the whole wall?
In most cases yes. Acoustic detection and a camera inspection locate the leak precisely before any tile is touched, so the opening is limited to the area where the fault actually sits.
Why is pressure weak at only one tap while all the others flow normally?
Scale from Kuwait's hard water usually clogs the aerator or cartridge inside that single tap. Removing the scale or replacing the small internal part restores normal flow without touching the pipe at all.
Do you work on old galvanised iron pipes or do you always recommend replacing them straight away?
We inspect first. If corrosion is localised a partial repair is viable. If the inner wall is heavily scaled along the whole run, full replacement saves more cost over time, and we explain this to the customer before any work begins.
Does fitting a new mixer or pipe joint require shutting water off to the whole building?
Most Kuwaiti homes have isolation valves serving individual zones or bathrooms, so the supply can be cut to just the repair area without affecting the rest of the building.
Can a sabbak handle a ground-floor sump or transfer pump fault or does that need a different specialist?
A sabbak inspects the pump, its connections and the associated pipe runs and determines whether the fault is mechanical or in the lines. If a deeper electrical issue is found we make that clear after diagnosis.
