Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Ahmadi
Epoxy tank lining in Julaiaa
Epoxy tank lining in Julaiaa begins with suctioning residual water then scraping peeling paint and salt buildup from walls. We high-pressure clean and allow complete drying before applying epoxy coats and complete the job with internal camera inspection.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Julaiaa's southern tanks are mostly on farms and small factories with medium capacity and relatively thin concrete walls. The main issue is water seeping through fine cracks and internal corrosion leaving white sediment on the floor and sides. Epoxy completely seals these cracks and stops water pressure from pushing against walls from inside. We measure coat thickness with a gauge after finishing to confirm we have met the required thickness.
Julaiaa is a desert area in southern Ahmadi where farms and commercial operations depend on sealed storage tanks.
We perform HD camera inspection after complete drying to document any coating defects before tank handover.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Julaiaa
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Julaiaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the tank be used right after epoxy application?
No, it needs full curing for at least twenty-four hours. We leave the tank ventilated for six additional hours after drying.
How do you handle large cracks in tank walls?
Wide cracks are filled with thick epoxy putty before liquid coating. This prevents air from remaining in the cracks and ensures permanent sealing.
