Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Jahra
Epoxy tank lining in Mutlaa
Epoxy tank lining on Mutlaa ridge starts with full drainage and scraping deposits from inner walls. We apply chemical cleaning and deep grinding then successive epoxy coats on every surface. We test seal and quality with camera before refilling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Mutlaa is a high desert ridge area with modern villas and overhead tanks under intense sun. Tanks here face harsh conditions from strong winds, extreme heat and heavy sand dust. Desalinated water used by the area leaves different deposits than well water causing particular wear at corners and the floor. Near Mutlaa peak where elevation is highest, the day-night temperature swing causes expansion and shrinkage that speeds crack growth.
Mutlaa sits in Jahra governorate, a high desert ridge where tanks face thermal stress and harsh winds more than other areas.
We measure epoxy thickness with an electromagnetic gauge after application to verify every spot reaches minimum required thickness.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Mutlaa
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Mutlaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the extreme day-night temperature swing on Mutlaa affect the epoxy coat?
The large swing causes thermal stress on epoxy but rated coats are tested for this pressure. We apply multiple thin coats instead of one thick coat because thin layers distribute across expansion and shrinkage better.
Do tanks on Mutlaa need re-coating sooner than tanks in other areas?
Yes, thermal stress and harsh winds age the coat about a year faster. We recommend camera checks every two years instead of three to catch small cracks before they worsen.
