Crack mapping by camera
Internal camera maps every crack and its depth before work begins
Jahra
Fibreglass tank repair in Salmi
Fibreglass tanks in Salmi sit near the border and need advanced inspection due to temperature and humidity swings from low plains. We inspect walls inside under strong light to trace fine cracks. We fill each crack with high-grade epoxy and run intensive hydrostatic testing before resuming use.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Border-area homes in Salmi keep fibreglass tanks on roofs or in open yards. The zone is humid some seasons and very dry in others, and the tank swells and shrinks fast. High humidity causes slow outer erosion, and cracks begin around internal stiffeners and the base. We remove the tank cover and enter with measuring gear to map cracks precisely before deep cleaning and filling each crack.
Salmi is a border zone north of Jahra near the Kuwait-Iraq crossing, where tanks face severe climate swings.
We test the tank at full fill for eight hours, measuring air humidity and any seepage at regular intervals.
What the repair covers
Surface preparation
Grinding the area around the crack ensures the resin bonds properly
Glass-mat laminate patch
Resin-saturated glass-mat layers fill the crack and restore structural stiffness
Delamination and wear repair
Delaminated sections are removed and rebuilt with matching laminate material
Drinking-water epoxy coat
Full interior coat with epoxy rated safe for potable water contact
Post-repair camera check
Camera confirms no remaining cracks or coating bubbles before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Fibreglass tank repair
Other services in Salmi
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Fibreglass tank repair in Salmi
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does high humidity speed up the development of new cracks?
Yes, humidity enters walls and causes local swelling and fibre weakening. If original cracks seal well, new cracks start in weaker zones of the tank.
Should the tank be refilled immediately after repair or should we wait?
We wait at least six hours for the epoxy to dry fully. In Salmi where humidity is high we may wait eight hours to ensure complete curing before adding water.
