Underground tank cleaning
Removing sediment, algae and buildup from walls and floor
Hawalli
Tank cleaning and waterproofing in Ministries Area
Tank cleaning and waterproofing in the Ministries Area starts with a thorough inspection of the floor, walls and roof inside, looking for sediment and fine cracks. We remove silt and suspended matter, rinse under pressure, then apply epoxy sealant to stop contaminated water seeping in.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Government buildings around the Ministries Complex rely on large centralised roof tanks supplying multiple floors. These tanks face intense sun heat and airborne dust, causing fine sediment buildup and cracks in the original coating. Our inspection reveals whether walls need old paint scraped off before sealing or whether quick-spray application will suffice. A properly sealed tank cuts water contamination from external factors.
The Ministries Area lies in Hawalli governorate, an administrative district where government buildings and central services cluster at high density.
After full drying, we test the tank by spraying pressurised water on every internal surface to detect any breach in the new seal.
What this service covers
Roof tank cleaning
Cleaning tanks exposed to heat and heavy mineral deposits
Epoxy tank lining
Safe epoxy coat that seals the surface and prevents contamination
Fibreglass tank repair
Patching cracks and relining degraded fibreglass tank walls
Tank welding
Closing fractures and openings in steel or polyethylene tanks
Water tank restoration
Full clean, repair and waterproof seal in one organised visit
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank cleaning and waterproofing
Other services in Ministries Area
Valve repair
See the detailsWater leak detection
See the detailsWater pipe runs
See the detailsWater pump install and service
See the detailsCommon questions
Questions about Tank cleaning and waterproofing in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How long does epoxy sealant take to cure fully before refilling?
Two-part epoxy needs at least 48 hours to cure in Kuwait heat. We leave the tank sealed and airless until the chemical set is complete.
Must the tank be cleaned before sealing or does sealant cover the dirt?
Cleaning and sealing are separate stages, both essential. Sealant will not adhere to a dirty surface and won't stop old sediment leaking through. We remove all buildup first, then apply sealant to a clean surface.
