Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Capital
Water tank restoration in Qibla
Water tank restoration in Qibla brings ageing rooftop tanks back to service in tall commercial and residential blocks. We inspect the inner walls for leaks, corrosion and sediment, repair cracks with cement injection, apply a protective coating and run a full pressure test.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Gulf Road buildings in Qibla carry large steel tanks on the roof serving many storeys, exposed to direct sun and sea salt spray from nearby. We check the tank wall thickness and surface rust, test the seams between plates and inlet and outlet pipes. Where we find localized corrosion we pressure-inject cement to seal micro-channels, then coat the inside surface with an epoxy barrier.
Qibla in the capital is a high-density commercial zone near the Gulf, where tenants depend on stable rooftop tanks for continuous water pressure.
We draw a water sample from the tank before restart because sediment from corrosion affects downstream feed quality.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Qibla
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Qibla
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the tank be repaired without completely emptying it?
No, the tank must be fully drained and cleaned before we can inspect the walls from inside. We pump the water to a temporary tank, then scrub the floor and walls free of silt and algae before repair begins.
How long does the interior coating take to cure?
Epoxy sets to touch in three hours but we do not refill the tank until twenty-four hours have passed. The full wait period matters because early moisture weakens the new coating.
