Fill valve
Adjusted or replaced when filling is slow, noisy or never stops.

Ahmadi
Cistern leaks in Bnaidar usually start with water dripping under the tank or fill noise that does not stop even after the tank is full. We climb to the tank, open the lid, check the fill valve, ball and waste outlet and pinpoint the fault exactly.
Homes and small shops in Bnaidar rely on small elevated cisterns to ensure adequate summer water pressure. These tanks fill slowly and drain quickly, exposing the valve to repeated harsh fill-drain cycles. We check the tank base on the roof and confirm bolts have not loosened from vibration, inspecting inside for rust and water leaks from joints.
Bnaidar in Ahmadi governorate is a small desert residential zone where residents depend on elevated tanks.
We test valve closure without grid pressure sometimes because small tanks may lose pressure quickly when the pump stops.
Adjusted or replaced when filling is slow, noisy or never stops.
Repaired when water trickles constantly from cistern to pan.
Set or replaced to restore the correct water level inside.
Checked and reseated when the joint leaks at floor level.
Broken or loose seats replaced on the same visit.
Wax or rubber seal replaced when water pools at the base.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, variable pressure strains the springs and internal bolts of the valve. We test spring tension after repair and replace it if it seems weak or stuck.
Not necessarily if rust is only surface-level. We brush the rust off with a wire brush, coat the inside with rust-inhibiting paint and allow drying time.
