Pipe repair
replacing the cracked or corroded section in PPR, uPVC or galvanised iron
Ahmadi
Leak repair in Maqwa
Leak repair in Maqwa starts by mapping every supply and waste line from the water meter to the house ends. We use ultrasonic detectors to hear the sound of water spurting from the small crack or hole. Once the point is pinned we open a very small section of wall or tile and replace or seal the faulty pipe. We re-pressure the whole system to ensure no other hidden leak exists.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Houses in Maqwa sit near Kuwait oil fields on unstable ground of sand and gravel. Pipes fixed in foundations experience slight movement from settling and rising, putting stress on joints and the pipes themselves. Leaks here usually occur at solder joints or where pipes were clamped too tightly. We inspect every joint after pressurizing and look for small drips that may only show under high pressure. If a joint is old we replace it entirely rather than tightening the nut.
Maqwa lies in Ahmadi governorate near production facilities, where the ground beneath most houses is sandy and unstable.
We conduct pressure testing at 3 bar for a full hour because ground movement may cause a delayed leak.
What leak repair covers
Joint and fitting repair
tightening or replacing a weeping fitting before damp spreads further
Targeted breaking
tiles or plaster opened only above the confirmed fault, nowhere else
Pressure test
pressurising the line after repair to confirm the leak is fully sealed
Scale clearance
clearing mineral scale from the pipe wall when the damaged section is replaced
Line reinstatement
reconnecting the line and restoring full flow before the technician leaves
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Leak repair
Other services in Maqwa
Non-destructive leak detection
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsAcoustic leak listening
See the detailsCommon questions
Questions about Leak repair in Maqwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does ground movement under the house cause all the leaks?
No, but it contributes. The leak could be from an old pipe, a manufacturing defect or from water pressure that is too high. We check pressure and history first before blaming ground movement.
After repair does the leak stop immediately or might it take time?
It stops immediately if we fixed the right spot. We continue checking for an hour under full pressure after the repair to confirm it does not return. If dampness appears a day later there may be another point we did not find.
