Pipe repair
replacing the cracked or corroded section in PPR, uPVC or galvanised iron
Hawalli
Leak repair in Ministries Area
Leak repair in Ministries Area begins by confirming the water loss point hidden under walls or floors before opening anything. We trace the supply line from its source to the fault and fix the pipe in place without unnecessary demolition. A hidden leak might be sitting at a shallow depth under tiles or a bent copper run inside the wall. We test pressure and flow after repair to confirm no second leak exists.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Ministry office buildings in the area have tall vertical supply lines and complex horizontal pipes connecting different floors and wings. When damp appears on a ceiling below or water seeps from a wall corner, the leak usually hides in a buried pipe beyond sight. We use a moisture meter first on walls and floors to pinpoint the exact leak zone, then open a small window in tiles or plaster to reach the pipe. Fixing at the spot means no need to replace long sections of lines running inside walls.
Ministries Area lies in Hawalli governorate near the Kuwait Government Ministries Complex and Civil Service Commission, containing many administrative buildings with intricate internal piping.
We pull every supply line under test pressure before closing to ensure no second hole exists in the same pipe.
What leak repair covers
Joint and fitting repair
tightening or replacing a weeping fitting before damp spreads further
Targeted breaking
tiles or plaster opened only above the confirmed fault, nowhere else
Pressure test
pressurising the line after repair to confirm the leak is fully sealed
Scale clearance
clearing mineral scale from the pipe wall when the damaged section is replaced
Line reinstatement
reconnecting the line and restoring full flow before the technician leaves
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Leak repair
Other services in Ministries Area
Non-destructive leak detection
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsAcoustic leak listening
See the detailsCommon questions
Questions about Leak repair in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you find a leak hidden inside a wall?
We use a moisture detector to see where water concentrates on the surface, then open a small hole in the wall at the highest damp spot. Once we see the pipe we inspect joints and bends to locate the exact hole.
Do you break the whole wall or just a small section?
We open only a small piece exactly at the leak spot, then cover it with matching material after repair. If another pipe runs nearby we widen the hole slightly to check that one too.
