Acoustic pipe listening
Sensitive sensor picks up leak noise through tiles and plaster
Hawalli
Non-destructive leak detection in Salwa
Non-destructive leak detection in Salwa starts with an acoustic sensor that we pass over walls and floors to pinpoint where water is escaping. We hear the distinctive sound of water behind the tiles and mark the exact spot before opening anything. We then confirm the position using electronic moisture probes. This way the homeowner avoids breaking large wall areas.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Salwa houses near Salwa Co-op are typically two or three storeys with roof-mounted water tanks, and leaks often come from hot water pipes that face high summer pressures. We locate the main line inside the walls then scan with the detector along the suspected route until we hear a strong signal. Where the leak sits deep under tiles, we use thermal imaging to see the difference between wet and dry patches.
Salwa lies in Hawalli governorate, a residential district of mid-rise apartments and family villas where internal leaks are common due to building age.
Before final confirmation, we open only one small test hole to see the damaged pipe with our own eyes.
What this service covers
In-pipe camera inspection
Flexible camera checks for cracks and corrosion inside supply lines
Suspect line mapping
Tracing the hidden pipe route to narrow the search zone
Floor and wall survey
Systematic check of suspect surfaces without lifting a single tile
Roof tank check
Confirming whether moisture source is the tank or a supply pipe
Leak location report
Exact leak point confirmed before the repair team is engaged
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Non-destructive leak detection
Other services in Salwa
Camera leak detection
See the detailsLeak repair
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsCommon questions
Questions about Non-destructive leak detection in Salwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell cold and hot water leaks apart?
Hot water leaves vapour in the wall, which we measure quickly with a moisture detector after turning off heating. Cold water spreads more slowly, so it takes longer. The difference helps us identify which line is leaking before we dig.
Can you find a leak behind expensive tiles without removing them?
Yes, the acoustic detector works through any material. We scan the surface from outside until we pinpoint the exact spot, then only open a small window in an inconspicuous place if we need visual confirmation.
