Acoustic pipe listening
Sensitive sensor picks up leak noise through tiles and plaster
Ahmadi
Non-destructive leak detection in Shuaiba Industrial
Non-destructive leak detection in Shuaiba Industrial begins by listening for water sounds and tracing wet patches on walls and floors. We use acoustic and thermal sensors to pinpoint the leak location inside concrete walls and ceiling slabs before any cutting work starts.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba Industrial factories contain complex pipe networks inside thick concrete walls and beneath solid floors, and one leak can travel metres from its source before showing on the surface. When we see a wet patch near a warehouse we start by measuring moisture along the top pipe run first, because water moves downward through concrete. We use a thermal camera to track the temperature difference between flowing water and surrounding walls, making the leak location clear without random cuts.
Shuaiba Industrial sits in Ahmadi governorate, a petrochemical factory zone where water leaks in buried pipes threaten production and safety.
We record moisture readings on a site map because a factory leak can affect several adjacent sections.
What this service covers
In-pipe camera inspection
Flexible camera checks for cracks and corrosion inside supply lines
Suspect line mapping
Tracing the hidden pipe route to narrow the search zone
Floor and wall survey
Systematic check of suspect surfaces without lifting a single tile
Roof tank check
Confirming whether moisture source is the tank or a supply pipe
Leak location report
Exact leak point confirmed before the repair team is engaged
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Non-destructive leak detection
Other services in Shuaiba Industrial
Camera leak detection
See the detailsLeak repair
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsCommon questions
Questions about Non-destructive leak detection in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you find a leak directly under a concrete factory floor?
We pass an acoustic detector over the surface to hear water running inside the buried pipe. Then we use a thermal camera to see the temperature difference on the floor, where a leak shows as a cold spot if the leaking water is flowing cold.
Must you break new pipes once you locate the leak?
Usually not, because we pinpoint the exact location before any work begins. If the leak is at a joint only, we can reach it from the side with a small cut instead of breaking an entire floor section.
