Ground tank survey
Locating leaks in walls and floor of a buried ground tank
Ahmadi
Tank leak detection in Shuaiba Industrial
Locating a tank leak at Shuaiba Industrial begins with a close external and floor inspection before any repair. We pinpoint the exact leak location using inspection tools and document the damage clearly so you know what to fix.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba Industrial tanks hold treated or process water and sit exposed on ground or concrete frames near the petrochemical works. Sea salt and coastal dampness accelerate tank body and floor corrosion, and small leaks spread fast in the heat. We inspect all welds, fitted pipes, openings and the tank floor, then establish whether the leak comes from a pipe defect or rust in the tank shell itself.
Shuaiba Industrial sits in Ahmadi governorate, a complex infrastructure zone where water tanks need routine inspection for operational and safety reasons.
We enter the tank with full safety gear and inspect floor and walls under direct light to catch any damp or wet spot.
What the service covers
Roof tank check
Inspecting the roof tank body and fittings for hairline cracks
Pressure test
Controlled pressure applied to confirm and pinpoint the fault location
Acoustic listening
Probe detects the leak sound through the tank wall or surrounding tiles
Fitting and inlet check
Checking inlet, outlet and overflow fittings where leaks often start
Leak location report
Owner receives a clear finding of where and what the fault is
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank leak detection
Other services in Shuaiba Industrial
Acoustic leak listening
See the detailsCamera leak detection
See the detailsLeak repair
See the detailsNon-destructive leak detection
See the detailsCommon questions
Questions about Tank leak detection in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell if the leak is in the tank floor and not the upper pipes?
We fill the tank gradually and watch where water appears outside, then inspect fitted pipes at each height level. If water only shows near the base the fault is in the lower shell.
Can you tell how deep the rust goes before we open the tank for repair?
We use a thickness gauge on the tank shell from outside to see how much metal remains. This tells us if the rust is surface or deep enough to threaten structural integrity.
