Ground tank survey
Locating leaks in walls and floor of a buried ground tank
Capital
Tank leak detection in Shuwaikh Industrial
Leak detection in tanks at Shuwaikh Industrial requires inspection of storage stations and tall tanks that feed machines and production lines. We enter the site by reference number and locate any leak in horizontal and vertical pipes before repair begins.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Factories and warehouses in Shuwaikh Industrial have overhead tanks mounted on strong steel frames and large-bore distribution pipes that reach multiple buildings quickly. Leaks here may be at clip connections or at bends where pressure is highest. We measure water pressure at the line start and trace pipes to the end of each branch and inspect every bolted joint for moisture.
Shuwaikh Industrial spans factories and warehouses along the Fourth Ring Road and relies on extensive pipe networks that connect production stages.
We test the main distribution line under full operating pressure and record any pressure drop every ten minutes to catch rapid leaks.
What the service covers
Roof tank check
Inspecting the roof tank body and fittings for hairline cracks
Pressure test
Controlled pressure applied to confirm and pinpoint the fault location
Acoustic listening
Probe detects the leak sound through the tank wall or surrounding tiles
Fitting and inlet check
Checking inlet, outlet and overflow fittings where leaks often start
Leak location report
Owner receives a clear finding of where and what the fault is
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank leak detection
Other services in Shuwaikh Industrial
Acoustic leak listening
See the detailsCamera leak detection
See the detailsLeak repair
See the detailsNon-destructive leak detection
See the detailsCommon questions
Questions about Tank leak detection in Shuwaikh Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
What is the difference between a tank leak and a leak in the pipes connected to it?
A tank leak shows continuously under the metal frame or around the base. A pipe leak is sporadic during operation only and leaves a wet trail along the run. We isolate the tank from the pipes and test each separately.
Can an overhead tank leak be repaired without emptying it completely?
Only if the leak is in a pipe below the water level that can be isolated. For leaks in the tank wall itself it must be emptied completely and allowed to dry before sealing cracks with epoxy compound.
