Pipe repair
replacing the cracked or corroded section in PPR, uPVC or galvanised iron
Capital
Leak repair in Shuwaikh Industrial
Leak repair in Shuwaikh Industrial requires locating the pipe inside concrete block walls before drilling. Factories and warehouses here rely on strong central supply for cooling and wash-down equipment, so any leak means noticeable water loss. We trace the line from the main inlet, test sections under high pressure, and replace weak pipes with ones rated for industrial pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Warehouses and factories in this area have large-bore pipes running across metal ceilings and wide concrete floors. These pipes are tested under high pressure from installation, but vibration from heavy machinery can wear joints or create small holes. We open roof access panels to inspect exposed pipes, and test each joint by holding steady pressure readings before sealing.
Shuwaikh Industrial lies in the capital's major industrial zone, housing factories and storage sheds with large-diameter pipes under constant pressure.
We test industrial lines at 10 bar for one hour and record gauge readings every five minutes because slow leaks may not show immediately.
What leak repair covers
Joint and fitting repair
tightening or replacing a weeping fitting before damp spreads further
Targeted breaking
tiles or plaster opened only above the confirmed fault, nowhere else
Pressure test
pressurising the line after repair to confirm the leak is fully sealed
Scale clearance
clearing mineral scale from the pipe wall when the damaged section is replaced
Line reinstatement
reconnecting the line and restoring full flow before the technician leaves
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Leak repair
Other services in Shuwaikh Industrial
Non-destructive leak detection
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsAcoustic leak listening
See the detailsCommon questions
Questions about Leak repair in Shuwaikh Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the leak be fixed while the factory is running?
No, the main valve must be shut off before we open the line. We may need one or two hours of full stoppage to inspect, replace the pipe section and run final tests.
Are copper pipes better than galvanised steel in factories?
Copper handles high pressure and vibration better, but galvanised steel is cheaper and lasts long if the supply is clean. We choose based on required pressure and available budget.
