Acoustic surface scan
Tracing the leak sound through tile and screed layers
Hawalli
Under-tile leak detection in Siddiq
Pinpointing the leak under tiles in Siddiq requires understanding the pipe density in this large residential district where multiple lines intersect beneath floors. We use thermal maps and pressure sensors to isolate the leaking line among many others.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most houses in Siddiq are dense and adjoining with small or no gardens, meaning supply and waste pipes are packed tightly under floors and some may be very old. When a leak occurs we need to distinguish between hot and cold water leaks because each follows a different route. We start by thermal mapping with infrared and a thermal camera, then run separate air pressure tests on each line to confirm which is broken.
Siddiq is a dense neighbourhood in Hawalli known for established family residential clusters, where most older piping approaches are still in use.
We check local service records to know the original pipe installation history before starting any detection test.
What this service covers
Pressure line test
Isolating the suspect line and measuring pressure drop to confirm fault location
In-line camera check
Filming inside the pipe from the nearest access point to view the crack
Leak point marking
Marking the exact spot on the tile surface to minimise breaking area
Concealed branch check
Checking pipe branches hidden inside the adjacent ceiling or wall
Link to leak repair
Handing the confirmed location directly to the repair team
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Under-tile leak detection
Other services in Siddiq
Non-destructive leak detection
See the detailsTank leak detection
See the detailsAcoustic leak listening
See the detailsCamera leak detection
See the detailsCommon questions
Questions about Under-tile leak detection in Siddiq
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell which leak is from hot water and which from cold water?
Hot water raises the temperature of surrounding tiles and mortar, so a warm patch shows clearly on thermal camera. Cold water does not change temperature, but we air-pressure test each line separately to confirm the source.
If many pipes cross underneath, do you need to break anything to find the leak?
In most cases no, because heat, pressure and sensing pinpoint the leaking line precisely. Breaking is only necessary when the leaking pipe is tangled with another and we cannot isolate it by testing.
