Pump diagnosis
Checking motor, impeller and flow rate before any replacement decision

Capital
Hot water circulation pump installation in Qibla starts by checking the existing copper runs in the house and verifying heater capacity. We loop from the ground-floor boiler to the furthest hot tap, fit the pump and isolation valves, then balance flow across each branch.
Qibla houses near the highway often have cramped plant rooms under stairs or in a corner, and the boiler may sit far from upper-floor bathrooms. We measure the hot-water run from boiler to furthest tap and assess whether the existing pump pushes enough flow. If pressure is weak we replace the pump with a stronger unit and fit a pressure-relief valve in the plant room to protect the copper pipework from sudden spikes.
Qibla sits near Gulf Road in a mixed commercial zone where old and new residential buildings stand side by side.
We test hot-water circulation by running each tap for one full minute because long runs need time to pull through.
Checking motor, impeller and flow rate before any replacement decision
Calculating loop length and building height to select the right pump
Mounting the pump on the return line with isolation valves on both sides
Fitting a check valve to prevent backflow and keep circulation directional
Setting pump speed and timer to cut energy use without delaying hot-water delivery
Filming inside the circulation line to spot scale restricting flow before installation
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Not usually, because modern pumps are smaller than older ones. We unbolt the old unit from the copper fittings and slide it out carefully, then fit the new one on the same brackets and studs.
After correct installation and balancing, hot water should arrive in under thirty seconds. If it takes longer there is air in the loop which we bleed from the top vent valve.
