Live pressure reading
Measuring cut-in and cut-out values before touching anything
Farwaniya
Pump pressure-switch repair in Hassawi
Pump-pressure-switch repair in Hassawi starts by reading the gauge on your roof tank to know the current pressure. We disassemble the switch, inspect and clean the springs and contacts of deposits, then reset the cut-in and cut-out points to match your home's needs.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Hassawi homes typically have an overhead tank and ground tank with a manual or automatic pump, and the pressure switch is what stops the pump when the upper tank fills. If pressure bounces or the pump won't stop, the switch usually needs cleaning or resetting. We first check the tank position and the water-to-ceiling distance to confirm the measured pressure is real before touching the switch itself.
Hassawi is a residential zone in Farwaniya governorate where most homes rely on overhead tanks and automatic pump systems.
After adjustment, the switch is tested by running water from the ground tank to full level to confirm the pump stops at the right pressure.
What the work covers
Expansion vessel check
Testing the air bladder charge and refilling it if pressure is lost
Switch repair or replacement
Cleaning contacts or fitting a new switch matched to pump capacity
Cut-in and cut-out setting
Calibrating both thresholds precisely to prevent rapid on-off cycling
Electrical terminal check
Inspecting wiring and terminal resistance at both switch contacts
Final run test
Running the pump and confirming stable pressure through a full cycle
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Pump pressure-switch repair
Other services in Hassawi
Basement sump pump
See the detailsCesspit pump
See the detailsHot-water circulation pump
See the detailsRoof-tank pump
See the detailsCommon questions
Questions about Pump pressure-switch repair in Hassawi
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does the pressure switch cut the pump before the overhead tank is full?
The switch reads air pressure in the tank, not water level, so if it is set too low it reaches cut-out before the tank is truly full. We raise the cut-out point based on your tank height and roof.
Does the pressure switch need regular inspection?
Yes, about every six months it should be opened and the contacts cleaned of oxidation and moisture since water leaves mineral traces that jam the contacts. A quick cleaning keeps the switch working for years.
