Tank and line check
Tank size and pipe run checked before any pump is chosen

Hawalli
Roof tank pump installation in Salwa begins by checking the existing tank and pipework. We select the right pump for pressure and flow, fit it onto the main line, and test delivery to every floor.
Houses in Salwa near Salwa Co-op are mostly three or four storey residential buildings. Tanks sit on flat roofs, and the distance from roof to ground floor is long enough to justify a calculated pump. We inspect the tank interior first, then check old pipe connections and spots that might leak under new pump pressure.
Salwa lies in Hawalli governorate, a residential zone where high tanks and long pipe runs make pumping a daily necessity.
We test the pump under full load for ten minutes because long pipe runs need stable settling.
Tank size and pipe run checked before any pump is chosen
Type and capacity matched to actual tank height and demand
Pump seated on isolation pads to stop vibration reaching the structure
Inlet and discharge lines fitted with non-return and isolation valves
Outlet pressure measured and confirmed stable under normal fixture load
All joints inspected for leaks before the job is signed off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
A modern pump on a roof tank runs in short cycles all day, filling the tank then stopping. This is better than continuous pumping because the tank stores water and covers peak demand hours.
We connect a pressure gauge to a supply point on the top floor and run the pump at full flow. The gauge should read at least three bar at the upper bathroom tap so the tank fills steadily from below.
