Roof tank installation
Polyethylene tank set on roof with supply, overflow and pump lines connected
Jahra
Water tank installation in Taima
Water tank installation in Taima takes longer due to distance and sandy roads that restrict heavy equipment movement. We choose a tank suited to the distance from the supply point and set it on a concrete pad slightly raised above the sandy ground. Supply and drain pipes are run carefully and protected from sand and thermal movement. Water testing is done before we leave.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Emerging Taima houses in the desert are built on flat sandy ground without deep foundations, so the tank cannot be easily buried. We build a strong concrete base slightly raised above ground level to avoid wet sand seepage and seasonal water. The desert heat and harsh sun cause significant thermal expansion in copper pipes, so we use moving clamps. Supply from a desert well may be very long, so we install a booster pump near the tank.
Taima sits in Jahra governorate within desert zones, where sand soil, new building and wide gaps between houses are typical.
Pipe thermal expansion is tested by running the tank in direct sun for two hours before final sealing.
What the installation covers
Underground tank construction
Watertight underground tank built with access hatches and rising main connected
Inlet and supply lines
Mains supply connected to tank with float valve and isolation fitted
Overflow and drain lines
Overflow routed away from the building at correct fall to prevent backflow
Pump connection
Transfer or pressure pump connected to tank and tested under load
System pressure test
Full network pressure test after installation confirms every joint holds
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank installation
Other services in Taima
Water pipe runs
See the detailsWater pump install and service
See the detailsCentral gas lines
See the detailsFirst-fix plumbing for new houses
See the detailsCommon questions
Questions about Water tank installation in Taima
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do copper pipes expand in desert heat?
Yes, significantly. We use split clamps that allow the pipe to slide slightly when heated. Small gaps are left between fixed joints to accommodate expansion.
Can the tank stay in direct sun all day?
Yes, modern tanks are made of high-density plastic or fibreglass and withstand heat. To extend lifespan, we can shade it with light metal or apply reflective paint.
